DU-180: Difference between revisions
m
no edit summary
mNo edit summary |
mNo edit summary |
||
| Line 130: | Line 130: | ||
*Select '''Garbage Truck''' mode | *Select '''Garbage Truck''' mode | ||
*Enter | *Enter the value for '''Top''' and click '''Save the parameters to device'''. | ||
*Enter the value '''Down''' and click '''Save the parameters to device'''. The Down must be less than the Top | *Enter the value '''Down''' and click '''Save the parameters to device'''. The Down must be less than the Top | ||
| Line 141: | Line 141: | ||
== '''<big>Dump truck mode</big>''' == | == '''<big>Dump truck mode</big>''' == | ||
This mode is designed to control the angle of inclination of various elements of vehicles: dump truck body, crane boom, tanker hatch, etc. The sensor will transmit the angle value via '''RS-485''' interface, and | This mode is designed to control the angle of inclination of various elements of vehicles: dump truck body, crane boom, tanker hatch, etc. The sensor will transmit the angle value via '''RS-485''' interface, and '''discrete outputs''' will trigger the crossing of control angles. | ||
[[File:Imagee12 d1c 1.png|center|frameless|832x832px]] | [[File:Imagee12 d1c 1.png|center|frameless|832x832px]] | ||
[[File:Imagecc32d1.png|center|frameless|766x766px]] | [[File:Imagecc32d1.png|center|frameless|766x766px]] | ||
In this mode, two angles '''Top and Down''' are set. To set the sensor in '''Dump truck''' mode: | |||
*Place the sensor in the operating position and press '''Set zero''' | |||
*Select '''Dump Truck''' mode | |||
*Enter the value for '''Top''' and click '''Save the parameters to device''' - Top control angle. | |||
*Enter the value for '''Down''' and click '''Save the parameters to device'''. The '''Down''' must be less than the Top - Down control angle | |||
*If necessary, set the '''network address''' and click '''Save the parameters to device''' again. | |||
When the triggering angles are crossed, the state of the discrete outputs will change according to the table. You can use both discrete outputs or one of them for triggering. | |||
[[File:Imagev23f23e.png|center|frameless|589x589px]] | |||
[[File:Imageasfdasf32r 2.png|center|frameless|822x822px]] | |||
== '''<big>Frequency mode</big>''' == | |||
This mode is used to control the tilt angle of a vehicle component when the head unit (terminal) '''does not have digital inputs'''. The angle is transmitted through the '''frequency channel''' (green wire) in the range of 300Hz (0) - 480Hz (180). | |||
The crossing of the control angle (parameter Down) is signaled by the disappearance of voltage on the purple output of the sensor. | |||
[[File:Imageqd21v1.png|center|frameless|789x789px]] | |||
To set the sensor in '''Frequency''' mode: | |||
*Place the sensor in the operating position and press '''Set zero''' | |||
*Select '''Frequency''' mode | |||
*Enter the value for '''Down''' and click '''Save the parameters to device'''. | |||
*If necessary, set the '''network address''' and click '''Save the parameters to device''' again. | |||
The operation of the purple output is described in the table: | |||
[[File:Imagecerb3b33 35t.png|center|frameless|520x520px]] | |||