DU-180: Difference between revisions
m
no edit summary
mNo edit summary |
mNo edit summary |
||
| Line 115: | Line 115: | ||
[[File:Imageb5b5g5t.png|center|frameless|938x938px]] | [[File:Imageb5b5g5t.png|center|frameless|938x938px]] | ||
= '''<big>Operating principle and mode settings</big>''' = | |||
DU-180 transmits the current angle via the '''RS-485''' interface ('''LLS''' protocol), or via the '''frequency interface''' ('''in Hz'''). The tilt angle value is within '''0–180 degrees''' ('''300–480 Hz'''). If the tilt angle '''exceeds''' 180 degrees, the countdown starts from '''0'''. Additionally, information about the '''operation''' is transmitted via '''discrete''' outputs. In this case, voltage appears or disappears on them. Discrete outputs '''(green and purple)''' should be connected to the '''contact registration''' device (for example, the analog terminal input) as Normally Open (or Normally Closed - depends on the mode) plus - the voltage at the terminals can be from '''4V to the power source '''voltage. '''It is prohibited to connect a load to discrete outputs'''. In addition, the DU-180 sensor can transmit the tilt angle relative to another DU-180 sensor, the so-called '''differential mode'''. In this case, the angle of one sensor relative to the other in '''Hz''' will be used. | |||
== '''<big>Garbage truck mode</big>''' == | |||
This mode is used to control the tilt angle of the garbage truck lifting frame. The current tilt angle will be transmitted via the '''RS-485''' interface, and the '''discrete''' outputs '''will transmit the triggering events (crossing the control angles)''' | |||
[[File:ImageWQEQWE12E1.png|center|frameless|713x713px]] | |||
[[File:Image312.png|center|frameless|772x772px]] | |||
This mode sets two angles Top and Down. To set the sensor angles in the Garbage Truck mode: | |||
*Place the sensor in the operating position and press '''Set Zero''' | |||
*Select '''Garbage Truck''' mode | |||
*Enter a value for '''Top''' and click '''Save the parameters to device'''. | |||
*Enter the value '''Down''' and click '''Save the parameters to device'''. The Down must be less than the Top | |||
*If necessary, set the '''network address''' and click '''Save the parameters to device''' again. | |||
After crossing the triggering angles, the state of the discrete outputs will change according to the table. It is possible to record the fact of a complete cycle of lifting and lowering of the waste container | |||
[[File:Imageqwdqwd21.png|center|frameless|693x693px]] | |||
[[File:Imaged2v2e23.png|center|frameless|848x848px]] | |||
== '''<big>Dump truck mode</big>''' == | |||
This mode is designed to control the angle of inclination of various elements of vehicles: dump truck body, crane boom, tanker hatch, etc. The sensor will transmit the angle value via '''RS-485''' interface, and by means of '''discrete outputs''' will trigger the crossing of control angles. | |||
[[File:Imagee12 d1c 1.png|center|frameless|832x832px]] | |||
[[File:Imagecc32d1.png|center|frameless|766x766px]] | |||