TD-BLE: Difference between revisions
→Alternative sealing for TD-BLE of the current design
| Line 458: | Line 458: | ||
Also included with the current TD-BLE is an alternative seal if a numbered seal is required. | Also included with the current TD-BLE is an alternative seal if a numbered seal is required. | ||
* | * The wire must be threaded through the hole in the sensor cover | ||
[[Файл:Альтернативная пломбировка шаг 1.png|425x425пкс]] | [[Файл:Альтернативная пломбировка шаг 1.png|425x425пкс]] | ||
* | * Thread both ends of the cable through the hole in the sensor head | ||
[[Файл:Альтернативная пломбировка шаг 2.png|643x643пкс]] | [[Файл:Альтернативная пломбировка шаг 2.png|643x643пкс]] | ||
* | * Pass both ends through the seal, tighten the cable and install the seal by pressing the protruding part of the seal | ||
[[Файл:Альтернативная пломбировка шаг 3.png|714x714пкс]] | [[Файл:Альтернативная пломбировка шаг 3.png|714x714пкс]] | ||