TD-BLE: Difference between revisions
→Level 7000
| Line 540: | Line 540: | ||
Level 7000 is an error code Short circuit. This indicates that there is dirt, water, chips or other impurities in the tubes. All of these can be highly conductive, while the sensor is designed to work with dielectrics such as fuel. | Level 7000 is an error code Short circuit. This indicates that there is dirt, water, chips or other impurities in the tubes. All of these can be highly conductive, while the sensor is designed to work with dielectrics such as fuel. | ||
[[ | [[File:Level 7000.png|frameless]] | ||
You should clean the sensor tubes - preferably by blowing them through the drain holes with compressed air. | You should clean the sensor tubes - preferably by blowing them through the drain holes with compressed air. | ||
| Line 548: | Line 548: | ||
== '''<big>Level 6500</big>''' == | == '''<big>Level 6500</big>''' == | ||
This code may indicate that the tubes have lost contact. This error code may be generated immediately after cutting the tubes. In this case, simply calibrate the sensor. | This code may indicate that the tubes have lost contact. This error code may be generated immediately after cutting the tubes. In this case, simply calibrate the sensor. | ||
[[ | [[File:Level 6500.png|none|thumb|'''<big>Level 6500 and CNT below 10000</big>''']] | ||
If this does not help, check the CNT. If the CNT is below 10,000, it is very likely that the tubes are not in contact with the sensor board. | If this does not help, check the CNT. If the CNT is below 10,000, it is very likely that the tubes are not in contact with the sensor board. | ||