DU-180: Difference between revisions
m
no edit summary
mNo edit summary |
mNo edit summary |
||
| Line 101: | Line 101: | ||
*Select the RS-485 tab ('''1''') | *Select the RS-485 tab ('''1''') | ||
*Select Fuel level sensor ('''2''') | *Select Fuel level sensor ('''2''') | ||
[[File:Imagefas f32r2.png|center|frameless|793x793px]] | |||
*When connecting for the first time, the phone should ask for access to the converter, click OK | |||
[[File:Imagej7j7j.png|center|frame|'''<big>Providing access to the C200M2 in the app</big>''']] | |||
* If such a request does not appear and the sensor is not detected, try connecting additional power to the sensor according to the connection diagram, also check that the power indication on the converter is active and that the OTG mode is enabled on the smartphone | |||
* If, after asking for permission, you receive the error “Unable to connect the device,” this is normal. Just select the fuel level sensor again. | |||
[[File:Imagen6n6h6y6.png|center|frame|'''<big>Error failed to connect device after requesting permission</big>''']] | |||
* If you are using a C200M inverter, you can connect an additional power supply to the inverter. To do this, you need to take a power supply for charging your smartphone with a microUSB connector and connect it to the C200M using the ADD PWR connector | |||
* Once connected successfully, you will see the main screen of the sensor. | |||
[[File:Imageb5b5g5t.png|center|frameless|938x938px]] | |||