TD-BLE: Difference between revisions
→Preparing the sensor
| Line 214: | Line 214: | ||
H - height of the tank at the installation point. <blockquote><big>'''ATTENTION!!!''' '''The minimum length''' of the tubes should not be less than '''15 cm (150 mm)'''. Otherwise, it will most likely not be possible to obtain adequate graphics. The maximum length of the tubes can reach '''6m.'''</big></blockquote> | H - height of the tank at the installation point. <blockquote><big>'''ATTENTION!!!''' '''The minimum length''' of the tubes should not be less than '''15 cm (150 mm)'''. Otherwise, it will most likely not be possible to obtain adequate graphics. The maximum length of the tubes can reach '''6m.'''</big></blockquote> | ||
[[ | [[File:Measuring height of the tank.png|none|thumb|938x938px|'''Measuring height of the tank''']] | ||
[[Файл:Измерение длины трубок.png|без|мини|846x846пкс|'''<big>Измерение длины трубок</big>''']] | [[Файл:Измерение длины трубок.png|без|мини|846x846пкс|'''<big>Измерение длины трубок</big>''']] | ||
Use a hacksaw to cut the tubes. When sawing, be careful not to damage the connection of the tubes to the circuit board inside the sensor head and to prevent metal shavings from falling into the tubes. | Use a hacksaw to cut the tubes. When sawing, be careful not to damage the connection of the tubes to the circuit board inside the sensor head and to prevent metal shavings from falling into the tubes. | ||