TD-BLE: Difference between revisions
→Calibration without fuel
| Line 143: | Line 143: | ||
In this case, make sure that the sensor tubes are empty and there is no fuel in them, but the centralizer must be inserted into the tubes. Leave the '''"Calibrate without fuel"''' switch '''(1)''' active (green) and press '''"Calibrate" (2)''' . The values above the Empty and Full buttons will change automatically.<gallery widths="300" heights="600" mode="nolines"> | In this case, make sure that the sensor tubes are empty and there is no fuel in them, but the centralizer must be inserted into the tubes. Leave the '''"Calibrate without fuel"''' switch '''(1)''' active (green) and press '''"Calibrate" (2)''' . The values above the Empty and Full buttons will change automatically.<gallery widths="300" heights="600" mode="nolines"> | ||
File:Calibration without fuel.png|alt= | |||
File:CNT before calibration.jpg|alt= | |||
File:CNT after calibration.jpg|alt= | |||
</gallery>If you calibrate the sensor without fuel, the operating range may change slightly. | </gallery>If you calibrate the sensor without fuel, the operating range may change slightly. | ||