ECargosens: Difference between revisions
m
no edit summary
(Created page with "thumb|'''<big>Current design: central unit, measurement unit</big>''' The load monitoring system '''eCargosens''' (hereinafter - '''“System”''') for vehicles with air suspension is designed to monitor the load of every axis of the vehicle’s chassis based on the measurement of the air pressure in the air suspension’s system. The '''eCargosens''' system consists of one eCargosens '''DS central unit''' (hereinafter - “'''central unit'''”) an...") |
mNo edit summary |
||
| Line 12: | Line 12: | ||
= '''<big>Operating and data transmission principles</big>''' = | = '''<big>Operating and data transmission principles</big>''' = | ||
The Sensors must be connected to the air suspension system of the vehicle. They measure the air pressure in the air suspension and calculate the weight that is distributed onto a particular axis based on a calibration table that must be created and saved in their memory. | The Sensors must be connected to the air suspension system of the vehicle. They measure the air pressure in the air suspension and calculate the weight that is distributed onto a particular axis based on a calibration table that must be created and saved in their memory. | ||
[[File:Imag1.png|center|frameless|754x754px]] | |||
The Sensor(s) transmit their parameters to the central unit via '''Bluetooth 5.0''' in accordance with the '''Escort BLE eCargosens''' data communication protocol. | |||
The Sensors transmit their data packages '''every 2 seconds'''. | |||
The air pressure is measured '''every 30 seconds''' but the measurement are filtered ('''median filtration''' 5) and then processed by a '''special algorithm'''. | |||
The central unit then retransmits the data received from the Sensor(s) to a GPS tracker/gateway via the '''RS-485''' interface in accordance with the '''LLS''' communication protocol. | |||
'''<big>The parameters transmitted by the Sensor(s):</big>''' | |||
- '''Weight''' or axle load in '''kg''' (provided that the '''calibration table''' is stored in a Sensor’s memory); | |||
- Air pressure in '''Pa'''; | |||
- Battery charge in '''V'''; | |||
'''<big>The parameters retransmitted by the central unit:</big>''' | |||
- '''Weight''' or axle load in '''kg''' (provided that the '''calibration table''' is stored in a Sensor’s memory); as received from the Sensor(s); | |||
- Air pressure in '''Pa'''; as received from the Sensor(s); | |||
- Battery charge in '''V'''; as received from the Sensor(s); | |||
- '''RSSI''' as calculated by the central unit for every Sensor in particular; | |||
= '''<big>Installation and configuration</big>''' = | |||
'''<big>Before installing the sensor you need to:</big>''' | |||
- Inspect the air suspension system; | |||
- Measure the diameter of the tubes that connect the air springs of the air suspension and buy the fittings to be able to connect the Sensors’ tubes to the air suspension’s tubes; | |||
The standard diameter of the Sensor’s tubes is ⌀ '''10mm'''. | |||
The Sensor’s connecting to the air spring is shown on the figures below: | |||
