TD-600: Difference between revisions
→Connection to the sensor, setup, calibration and calibration via the configurator on a PC
| Line 116: | Line 116: | ||
After starting the installation of components, you must wait for the message that the installation is complete, this may take a long time on some computers. | After starting the installation of components, you must wait for the message that the installation is complete, this may take a long time on some computers. | ||
[[ | [[File:Runtimepack installation.png|frameless]] | ||
'''Connect the sensor to the USB-RS-485 converter using a 6-pin MOLEX connector''' or using cable clamps if a cable route is connected to the sensor. Orange wire is line A of the RS-485 sensor interface, white wire is line B of the RS-485 sensor interface, black wire is GND, red is PWR. | '''Connect the sensor to the USB-RS-485 converter using a 6-pin MOLEX connector''' or using cable clamps if a cable route is connected to the sensor. Orange wire is line A of the RS-485 sensor interface, white wire is line B of the RS-485 sensor interface, black wire is GND, red is PWR. | ||
[[ | [[File:Sensor connected via MOLEX.png|none|thumb|759x759px|'''<big>Sensor connected via MOLEX</big>''']] | ||
[[ | [[File:Sensor connected via cables and cable clamps.png|none|thumb|758x758px|'''<big>Sensor connected via cables and cable clamps</big>''']] | ||
We recommend using our Escort C200M/C200M2 USB-RS-485 converter, since we cannot guarantee 100% compatibility of our devices with converters from other brands. | We recommend using our Escort C200M/C200M2 USB-RS-485 converter, since we cannot guarantee 100% compatibility of our devices with converters from other brands. | ||