TD-150-BLE: Difference between revisions
→Tilted tank calibration with 2 FLSs
| Line 584: | Line 584: | ||
You add the first portion of fuel to the tank. The level should change from 115 to some other value. If the level does not change, check the sensor drain holes. They may be blocked by electrical tape, which must be removed after the sensor has been calibrated. If the holes are blocked, the air inside the tubes will prevent fuel from getting inside the tubes. | You add the first portion of fuel to the tank. The level should change from 115 to some other value. If the level does not change, check the sensor drain holes. They may be blocked by electrical tape, which must be removed after the sensor has been calibrated. If the holes are blocked, the air inside the tubes will prevent fuel from getting inside the tubes. | ||
[[ | [[File:Adding a second portion to the tank.png|frameless|429x429px]] | ||
Next, add the following row to your table. | Next, add the following row to your table. | ||
[[ | [[File:Wired Extended table.png|frameless]] | ||
Continue this until the tank is full. | Continue this until the tank is full. | ||