DU-180: Difference between revisions
m
no edit summary
(Created page with " Русская версия Versión en español = <big>'''Definition and purpose of the sensor'''</big> = frame|Current DU-180 design Definition and purpose of the sensor Angle sensor '''"ESCORT DU-180”''' (hereinafter – '''sensor''') designed to measure tilting angle of tilting parts of different machinery and mechanisms (for example: excavator bucket, jib crane). It provides, in cooperation with '''GPS/GLO...") |
mNo edit summary |
||
| Line 34: | Line 34: | ||
= '''<big>DU-180 sensor's design</big>''' = | = '''<big>DU-180 sensor's design</big>''' = | ||
== '''<big>DU-180 sensor's design</big>''' == | |||
[[File:Imageda12121.png|center|frameless|816x816px]] | |||
== '''<big>Scope of Supply</big>''' == | |||
[[File:Imageq`23`.png|center|frameless|826x826px]] | |||
= '''<big>Connection to the sensor, setup via [https://www.fmeter.ru/download/_ftp/datchik-ugla-naklona/eskort-du-180/DU180_Configurator.zip?v=080824215802 the configurator on a PC]</big>''' = | |||
In order to connect '''DU-180''' to the computer you will need an '''RS-485-USB''' adapter (we recommend using Escort '''C200M and C200M2'''). Strictly follow the connection algorithm described below. [https://www.fmeter.ru/download/_ftp/eng/datchik-ugla-naklona/eskort-du-180/DU180_Configurator.zip?v=080824215912 Download] and install the configurator '''1.0.2.38'''. This will install the drivers for the C200M converter. If '''other model''' of converter is used, install the driver for it. | |||
'''1'''. Open the '''configurator''' | |||
'''2'''. Connect the converter to the computer (the sensor '''must be de-energized''') | |||
[[File:Imageasf 134 134 .png|center|frameless|829x829px]] | |||
'''3'''. '''Select (1)''' the '''COM port''' that appears (selected automatically if only one external device is connected as a virtual serial port) | |||
[[File:Imagedas 2131.png|center|frameless|798x798px]] | |||
'''4'''. Connect '''DU-180''' to the converter and '''press (2)''' DU 180 in the configurator (this must be done '''in the first 15 seconds''' after connecting the sensor to the power supply or to the converter using the connector). After that, the DU-180 settings interface should be displayed. If this does not happen, then disconnect the sensor connector from the converter, the converter from the computer connector, close the configurator and start the connection from '''point 1.''' | |||
[[File:Imageda sdad23.png|center|frameless|831x831px]] | |||
[[File:Imageda c3d3g4.png|center|frameless|798x798px]] | |||
