DB-2: Difference between revisions
→CONFIGURATION
| Line 205: | Line 205: | ||
== '''CONFIGURATION''' == | == '''CONFIGURATION''' == | ||
Use the [https://www.fmeter.ru/download/_ftp/eng/datchik-urovnja-sypuchih-produktov/eskort-db-2/DB2_Configurator.zip?v=270624163916 configurator] to configure the sensor. The program window is shown below. | Use the [https://www.fmeter.ru/download/_ftp/eng/datchik-urovnja-sypuchih-produktov/eskort-db-2/DB2_Configurator.zip?v=270624163916 configurator] to configure the sensor. The program window is shown below. | ||
[[File:DB-2 configurator interface.png|alt=DB-2 configurator interface|none|thumb|900x900px|DB-2 configurator interface]] | |||
[[ | [[File:DB2 connecting to laptop.png|alt=DB-2 to laptop connection|thumb|DB-2 to laptop connection]] | ||
ATTENTION! After turning on the sensor's power, its output is in RS-485 mode for 15 seconds. This allows you to connect a sensor that is in a mode other than RS-485 for configuration. | |||
[[ | |||
Connect the USB-RS485 converter “Escort C-200M2” or similar to the computer, and the sensor to the converter in accordance with the diagram presented. Do not connect the red wire. | Connect the USB-RS485 converter “Escort C-200M2” or similar to the computer, and the sensor to the converter in accordance with the diagram presented. Do not connect the red wire. | ||
| Line 227: | Line 226: | ||
If the driver was installed correctly, then after connecting the converter to your PC/laptop, you will see the STMicroelectronics Virtual COM Port ('''1''')(C200M) or USB-SERIAL CH341A ('''2''')(C200M2) device in the COM and LPT ports section of the Windows device manager " to enter this menu, press '''win+r''' and enter '''devmgmt.msc''' and press '''OK''' ('''3''') and then expand the com ports submenu ('''4''')" | If the driver was installed correctly, then after connecting the converter to your PC/laptop, you will see the STMicroelectronics Virtual COM Port ('''1''')(C200M) or USB-SERIAL CH341A ('''2''')(C200M2) device in the COM and LPT ports section of the Windows device manager " to enter this menu, press '''win+r''' and enter '''devmgmt.msc''' and press '''OK''' ('''3''') and then expand the com ports submenu ('''4''')" | ||
The com port number displayed in this menu is also needed to connect the sensor.</blockquote>[[ | The com port number displayed in this menu is also needed to connect the sensor.</blockquote> | ||
[[File:Start DB-2 configuration.png|alt=Start DB-2 configuration|thumb|Start DB-2 configuration]] | |||
=== '''<big>Connecting to the sensor in the configurator</big>''' === | === '''<big>Connecting to the sensor in the configurator</big>''' === | ||