TD-150: Difference between revisions
→Alternative sealing of a current sample sensor
| Line 746: | Line 746: | ||
<gallery widths="400" heights="400"> | <gallery widths="400" heights="400"> | ||
File:Installing a seal on a wired FLS.png|'''<big>Installing a seal on a wired FLS</big>''' | |||
File:Installed seal on the wired FLS.png|'''<big>Installed seal on a wired FLS</big>''' | |||
</gallery>To remove the seal, screw the special key from the kit into it (you can also use any self-tapping screw of a suitable size) and pull it towards you. | </gallery>To remove the seal, screw the special key from the kit into it (you can also use any self-tapping screw of a suitable size) and pull it towards you. | ||
[[File:Removal of the seal of the wired FLS.png|none|thumb|515x515px|'''<big>Removal of the seal of the wired FLS</big>''']] | |||
[[File:Seal after removal.png|none|thumb|'''<big>Seal after removal</big>''']] | |||
Thus, it will be impossible to remove the seal without damaging it. This provides additional protection against unauthorized access. | Thus, it will be impossible to remove the seal without damaging it. This provides additional protection against unauthorized access. | ||
| Line 757: | Line 758: | ||
Also included with the sensor of the current sample is an alternative seal if a numbered seal is required. | Also included with the sensor of the current sample is an alternative seal if a numbered seal is required. | ||
* It is necessary to pass the cable through the hole in the sensor cover [[ | * It is necessary to pass the cable through the hole in the sensor cover | ||
* [[File:Alternative sealing of wired FLS step 1.png|frameless|432x432px]] | |||
* Pass both ends of the cable through the hole in the sensor head [[ | * Pass both ends of the cable through the hole in the sensor head | ||
* [[File:Alternative sealing of wired FLS step 2.png|frameless|435x435px]] | |||
* Pass both ends through the seal, tighten the cable and install the seal by pressing on the protruding part [[ | * Pass both ends through the seal, tighten the cable and install the seal by pressing on the protruding part | ||
* [[File:Alternative sealing of wired FLS step 3.png|frameless|555x555px]] | |||
== '''<big>Sealing sensor of the former design</big>''' == | == '''<big>Sealing sensor of the former design</big>''' == | ||
[[ | [[File:Sealing sensor of the former design.png|frameless|512x512px]] | ||
== '''<big>Cable sealing</big>''' == | == '''<big>Cable sealing</big>''' == | ||
To seal the sensor connector, insert a plastic seal into the special hole on the sensor connector | To seal the sensor connector, insert a plastic seal into the special hole on the sensor connector | ||
[[ | [[File:Wire sealing.png|frameless|493x493px]] | ||
= '''<big>Updating the sensor firmware</big>''' = | = '''<big>Updating the sensor firmware</big>''' = | ||