TD-150: Difference between revisions
→Tank calibration
| Line 551: | Line 551: | ||
Install the sensor into the tank of the installed tube in the previously drilled hole ø 30-35 mm. Make sure '''the gasket is installed''' between the sensor and the tank. After this, screw the screws from the installation kit into the previously drilled ø 3mm holes.<gallery widths="700" heights="400"> | Install the sensor into the tank of the installed tube in the previously drilled hole ø 30-35 mm. Make sure '''the gasket is installed''' between the sensor and the tank. After this, screw the screws from the installation kit into the previously drilled ø 3mm holes.<gallery widths="700" heights="400"> | ||
File:Installing the sensor inside the tank.png|'''<big>Installing the sensor inside the tank</big>''' | |||
File:Screwing the self-tapping screws.png|'''<big>Tightening screws</big>''' | |||
</gallery>Proceed to tank calibration. This procedure will result in a "level-liters" (or "level-gallons") table that will allow your monitoring platform to convert the level values that the sensor provides into liters/gallons that are displayed in the monitoring platform reports. | </gallery>Proceed to tank calibration. This procedure will result in a "level-liters" (or "level-gallons") table that will allow your monitoring platform to convert the level values that the sensor provides into liters/gallons that are displayed in the monitoring platform reports. | ||
| Line 565: | Line 565: | ||
Then go to the tank calibration menu | Then go to the tank calibration menu | ||
[[ | [[File:Wired tank calibration mobile.png|frameless|924x924px]] | ||
Then, you can click '''Start''' to create a new table, or click '''Resume''' to select an existing table from your smartphone memory and continue working with it. If you click '''Resume''', you will need to locate the table file on your Android device that you created/downloaded earlier. Select another folder using the Main Menu button ('''1''') or using the drop-down menu ('''2'''). Select the table and click on it ('''3''')<gallery mode="nolines" widths="300" heights="700"> | Then, you can click '''Start''' to create a new table, or click '''Resume''' to select an existing table from your smartphone memory and continue working with it. If you click '''Resume''', you will need to locate the table file on your Android device that you created/downloaded earlier. Select another folder using the Main Menu button ('''1''') or using the drop-down menu ('''2'''). Select the table and click on it ('''3''')<gallery mode="nolines" widths="300" heights="700"> | ||