TD-150: Difference between revisions
→Tilted tank calibration with 2 FLSs
| Line 293: | Line 293: | ||
Once the tank is full, you will have a calibration chart like the following example. | Once the tank is full, you will have a calibration chart like the following example. | ||
[[ | [[File:Tank is full.png|frameless|499x499px]][[File:Filled tank calibration table.png|frameless|446x446px]] | ||
[[File:Table for tank that can't be filled completely.png|none|thumb|'''<big>Table for a tank that cannot be filled 100%</big>''']] | |||
If in your case the level does not reach 1023 or 4095 because the tank cannot be filled completely, do not worry about it. It is acceptable that your table would end up like the following example, even though the sensor range is 1-1023. | |||
The number of servings depends on the capacity of the tank. See the table with our recommendations below. | The number of servings depends on the capacity of the tank. See the table with our recommendations below. | ||
{| class="wikitable" | {| class="wikitable" | ||
| Line 326: | Line 326: | ||
|} | |} | ||
<blockquote><big>The '''rule of thumb''': more portions means more accurate reports on the monitoring platform.</big></blockquote>You can create a table on your platform by loading it from a file or by entering values manually. | <blockquote><big>The '''rule of thumb''': more portions means more accurate reports on the monitoring platform.</big></blockquote>You can create a table on your platform by loading it from a file or by entering values manually. | ||
[[ | [[File:Loading the table on Wialon (example). .png|none|thumb|487x487px|'''<big>Loading the table on Wialon (example). Don't forget to check “Generate XY pairs” box</big>''']] | ||
== '''<big>Tilted tank calibration with 2 FLSs</big>''' == | == '''<big>Tilted tank calibration with 2 FLSs</big>''' == | ||